Comtrol ROCKETLINX ES8509-XT User Manual page 183

Port Mirroring (continued)
Switch# show mirror
Mirror Status : Enabled
Ingress Monitor Destination Port : gi6
Display
Egress Monitor Destination Port : gi6
Ingress Source Ports :gi1,gi2,
Egress Source Ports :gi1,gi2,
Event Log
Switch# show event-log
<1>Jan
Display
<2>Jan
<3>Jan
<4>Jan
Topology Discovery (LLDP)
Switch(config)# lldp
holdtime
run
Enable LLDP
timer
Switch(config)# lldp run
LLDP is enabled!
Switch(config)# lldp holdtime
<10-255>
Change LLDP
timer
Switch(config)# lldp timer
<5-254>
Ping
Switch# ping 192.168.11.14
PING 192.168.11.14 (192.168.11.14): 56 data bytes
64 bytes from 192.168.11.14: icmp_seq=0 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=1 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=2 ttl=128 time=0.0 ms
Ping IP
64 bytes from 192.168.11.14: icmp_seq=3 ttl=128 time=0.0 ms
64 bytes from 192.168.11.14: icmp_seq=4 ttl=128 time=0.0 ms
--- 192.168.11.14 ping statistics ---
packets transmitted, 5 packets received, 0% packet loss
round-trip min/avg/max = 1.3/1.3/1.4 ms
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
1 02:50:47 snmpd[101]: Event: Link 4 Down.
1 02:50:50 snmpd[101]: Event: Link 5 Up.
1 02:50:51 snmpd[101]: Event: Link 5 Down.
1 02:50:53 snmpd[101]: Event: Link 4 Up.
Specify the holdtime of LLDP in seconds
Enable LLDP
Set the transmission frequency of LLDP in seconds
Valid range is 10~255
Valid range is 5~254
Configuration Using the Command Line Interface (CLI)
Monitor and Diag (CLI) - 183