Mstp Port Configuration - Comtrol ROCKETLINX ES8509-XT User Manual

Configuration Using the Web Interface

MSTP Port Configuration

This page allows you to configure the port settings. Choose the Instance ID that you want to configure.
MSTP Port Configuration Page
Instance ID
Port Configuration
Path Cost
Port Priority
Link Type
Edge Port
Apply
80 - MSTP Port Configuration
Select an Instance ID to display and modify MSTP instance setting.
The cost of the path to the other bridge from this transmitting bridge at the
specified port. Enter a number from 1 through 200000000.
Decide which port should be blocked by priority on your LAN. Enter a number
from 0 through 240 in increments of 16.
Some of the rapid state transactions that are possible within RSTP are
dependent upon whether the port in question is connected to exactly one other
bridge (that is, it is served by a point-to-point LAN segment), or if it's
connected to two or more bridges (that is, it is served by a shared medium
LAN segment). This configuration allows the p2p status of the link to be
controlled by an administrator.
Present in implementations that support the identification of edge ports. All
ports directly connected to end stations cannot create bridging loops in the
network and can thus directly transition to forwarding, and skipping the
listening and learning stages. When the non-bridge device connects an edge
port, this port is in a blocking state and turn to forwarding state in 2*Hello
Time seconds. When the bridge device connects an edge port, this port is a
non-edge port automatic.
Click the Apply button to apply the configuration.
Note: You must Save the settings
settings if the ES8509-XT is powered off.
(Page 127), if you want to maintain these
RocketLinx ES8509-XT User Guide: 2000557 Rev. D