Vlan Configuration - Comtrol ROCKETLINX ES8509-XT User Manual

Configuration Using the Web Interface
• PVLAN Port Configuration
• PVLAN Information
• GVRP Configuration
Optionally, you can use the CLI for configuration, see

VLAN Configuration

Use this page to assign the Management VLAN, create the static VLAN, and assign the Egress rule for the
member ports of the VLAN.
VLAN Configuration Page
The management VLAN ID is the VLAN ID of the CPU interface so that only member
ports of the management VLAN can ping and access the switch. The default
Management VLAN
management VLAN ID is 1.
ID
Click Apply after you enter the VLAN ID.
You can assign a VLAN ID and VLAN Name for the new static VLAN.
•
•
Static VLAN
Click Add to create a new VLAN. The new VLAN displays in the Static VLAN
Configuration table. After creating the VLAN, the status of the VLAN remains Unused,
until you add ports to the VLAN.
Note: Before changing the management VLAN ID by web or Telnet, remember that the
88 - VLAN Configuration
on Page 93
on Page 94
on Page 95
VLAN ID: This is used by the switch to identify different VLANs. A valid VLAN ID
is between 1 and 4,094, 1 is the default VLAN.
VLAN Name: This is a reference for the network administrator to identify different
VLANs. The VLAN name may up to 12 characters in length. If you do not provide a
VLAN name, the system automatically assigns a VLAN name. The rule is VLAN
(VLAN ID).
port attached by the administrator should be the member port of the management
VLAN; otherwise the administrator cannot access the switch through the
network. The ES8509-XT supports a maximum of 256 VLANs.
VLAN (CLI) on Page 161.
RocketLinx ES8509-XT User Guide: 2000557 Rev. D