Table of Contents
Advertisement
Port Configuration Page
State
Speed/Duplex
Flow Control
Description
Apply
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
You can enable or disable the state of this port. Once you click Disable, the
port stops to link to the other end and stops to forward any traffic. The
default setting is Enable which means all the ports are workable when you
receive the ES8509-XT.
You can configure port speed and duplex mode of each port. Below are the
selections you can choose:
•
Gigabit Ethernet Port 1~ 9: (gi1~gi9)
-
Auto Negotiation (default)
-
10M full-duplex (10 Full)
-
10M half-duplex (10 Half)
-
100M full-duplex (100 Full)
-
100M half-duplex (100 Half)
-
1000M full-duplex (1000 Full)
Enable means that you need to activate the flow control function of the
remote network device in order to let the flow control of that corresponding
port on the switch to work.
Disable (default) means that you do not need to activate the flow control
function of the remote network device, as the flow control of that
corresponding port on the switch works.
Click this field if you want to enter a port description.
Click Apply to apply the settings.
Note: You must Save the settings
settings if the ES8509-XT is powered off.
Configuration Using the Web Interface
(Page
127), if you want to maintain these
Port Control - 67
Advertisement
Table of Contents
