Comtrol ROCKETLINX ES8509-XT User Manual page 150

Configuration Using the Command Line Interface (CLI)
Port Status
Switch# show interface gi1
Interface gigabitethernet1
Administrative Status : Enable
Operating Status : Connected
Duplex : Full
Speed : 100
Flow Control :off
Default Port VLAN ID: 1
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Port Status
Mdix mode is Disable.
Medium mode is Copper.
Switch# show sfp ddm
Port 8
Temperature:N/A
Tx power:N/A
Rx power:N/A
Port 9
Temperature:64.00 C <range :0.0-80.00>
Tx power:-6.0 dBm <range : -9.0 - -4.0>
Rx power:-30.0 dBm <range: -30.0 - -4.0>
Note: Administrative Status -> Port state of the port. Operating status -> Current status of the
port. Duplex -> Duplex mode of the port. Speed -> Speed mode of the port. Flow control -
> Flow Control status of the port.
Rate Control
Switch(config-if)# rate-limit
egress
Rate Control
– Ingress or ingress
Egress
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Switch(config-if)# rate-limit ingress mode
all
broadcast
Rate Control
– Filter
flooded-unicast
Packet Type
multicast
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
150 - Port Configuration (CLI)
show SFP DDM information
Outgoing packets
Incoming packets
Limit all frames
Limit Broadcast frames
Limit Broadcast, Multicast and flooded unicast frames
Limit Broadcast and Multicast frames
RocketLinx ES8509-XT User Guide: 2000557 Rev. D