Table of Contents
Advertisement
Configuration Using the Web Interface
VLAN Port Configuration
The VLAN Port Configuration page allows you to configure VLAN port parameters on a specific port. These
parameters include the port VLAN ID (PVID), Tunnel Mode, Accept Frame Type and Ingress Filtering.
VLAN Port Configuration Page
Enter the port VLAN ID (PVID). The PVID allows the switches to identify which port belongs to
which VLAN. To keep things simple, it is recommended that PVID is equivalent to VLAN IDs.
PVID
The values of PVIDs are from 0 to 4,095 (0 and 4,095 are reserved), 1 is the default value; 2 to
4,094 are valid and available in this column Enter the PVID you want to configure.
None - IEEE 802.1Q tunnel mode is disabled.
802.1Q Tunnel: QinQ is applied to the ports which connect to the C-VLAN. The port receives a
tagged frame from the C-VLAN. You need to add a new tag (Port VID) as an S-VLAN VID. When
the packets are forwarded to the C-VLAN, the S-VLAN tag is removed. After 802.1Q Tunnel
mode is assigned to a port, the egress setting of the port should be Untag, it indicates that the
egress packet is always untagged. This is configured in the Static VLAN Configuration table
(Page
88).
Tunnel
Mode
802.1Q Tunnel Uplink: QinQ is applied to the ports which connect to the S-VLAN. The port
receives a tagged frame from the S-VLAN. When the packets are forwarded to the S-VLAN, the
S-VLAN tag is kept. After 802.1Q Tunnel Uplink mode is assigned to a port, the egress setting of
the port should be Tag, it indicates that the egress packet is always tagged. This is configured in
the Static VLAN Configuration table
Uplink is 10, the VID of C-VLAN/Tunnel is 5. The 802.1Q Tunnel port receives Tag 5 from C-
VLAN and adds Tag 10 to the packet. When the packets are forwarded to S-VLAN, Tag 10 is
kept.
This defines the accepted frame type of the port. There are two modes you can select:
•
Admit All mode means that the port can accept both tagged and untagged packets. When
you select Admit All, untagged frames or Priority-Tagged only frames received on this port
Accept
are accepted and assigned to the PVID for this frame. This control does not affect VLAN
Frame
independent BPDU frames, such as Super Ring, STP, GVRP and LACP. It does affect VLAN
Type
dependent BPDU frames, such as GMRP.
•
Tag Only mode means that the port can only accept tagged packets.When you select Tag Only
the ES8509-XT discards untagged frames or Priority-Tagged only frames received on this
port.
90 - VLAN Port Configuration
(Page
88). For example, if the VID of S-VLAN/Tunnel
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
Advertisement
Table of Contents
