Stp Port Configuration - Comtrol ROCKETLINX ES8509-XT User Manual

STP Port Configuration

This page allows you to configure the port parameter after you have enabled STP, RSTP, or MSTP.
STP Port Configuration Page
You can enable/disable STP/RSTP/MSTP on a port by port basis. You can disable the STP state
STP State
when connecting a device in order to avoid STP waiting periods.
The cost of the path to the other bridge from this transmitting bridge at the specified port.
Path Cost
Enter a number from 1 through 200000000.
Port Decide which port should be blocked by priority on your LAN. Enter a number from 0 - 240 in
Priority increments of 16.
Some of the rapid state transactions that are possible within RSTP are dependent upon
whether the port in question is connected to exactly one other bridge (that is, it is served by a
Link Type point-to-point LAN segment), or if it is connected to two or more bridges (that is., it is served
by a shared medium LAN segment). This configuration allows the p2p status of the link to be
controlled by an administrator.
Present in implementations that support the identification of edge ports. All ports directly
connected to end stations cannot create bridging loops in the network and can thus directly
transition to forwarding, and skipping the listening and learning stages.
Edge Port
When a non-bridge device connects an edge port, this port is in a blocking state and turn to
forwarding state in 2*Hello Time seconds. When the bridge device connects an edge port, this
port is a non-edge port automatic.
Click Apply to apply the settings.
Apply
Note: You must Save the settings
ES8509-XT is powered off.
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
(Page 127), if you want to maintain these settings if the
Configuration Using the Web Interface
STP Port Configuration - 75