Configuring 802.1X Settings - 3xLogic VX-2S-CPIR-W User Manual

NOTE: A reboot is required for the settings to take effect.

CONFIGURING 802.1X SETTINGS

IEEE 802.1X. Settings can be configured in this section. The IEEE 802.1X standard is supported by the
network camera, and when the feature is enabled, the camera data is secured and user
authentication is needed when connecting the camera to the network protected by IEEE 802.1X.
Before you start:
The authentication server must be configured. Please apply and register a user name and password
for 802.1X in the server.
For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The password
should be something of your own choosing (using a minimum of 8 characters, including at
least three of the following categories: upper case letters, lower case letters, numbers and
special characters) in order to increase the security of your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
Steps:
1. Enter the 802.1X Settings interface: Configuration > Network > Advanced Settings > 802.1X
2. Check the Enable IEEE 802.1X checkbox to enable the feature.
3. Configure the 802.1X settings, including Protocol, EAPOL version, User Name, Password and
Confirm.
NOTE: The EAPOL version must be identical with that of the router or the switch.
4. Enter the user name and password to access the server.
5. Click Save to finish the settings.
NOTE: A reboot is required for the settings to take effect.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
802.1X Settings
Figure 9-16
USER MANUAL| VX-2S-CPIR-W
71