Table of Contents
Advertisement
connect seamlessly and to simplify the implementation of networks in the home and corporate
environments.
With this function enabled, there is no need to configure the port mapping for each port, and the
camera is connected to the Wide Area Network via the router.
Steps:
1.
Enter the NAT settings interface: Configuration > Network > Basic Settings > NAT.
2.
Check the checkbox to enable the UPnP™ function.
3.
Choose a nickname for the camera, or you can use the default name.
4.
Select the port mapping mode. Manual and Auto are selectable. F manual port mapping, you can
customize the value of the external port.
5.
Click Save to save the settings.
9.2 Configure Advanced Settings
In Advanced Settings, a user can configure technical parameters such as SNMP, FTP, Email, HTTPS,
QoS, 802.1x, etc..
CONFIGURING SNMP SETTINGS
You can set the SNMP function to get camera status, parameters and alarm related information, and
manage the camera remotely when it is connected to the network.
Before you start:
Before setting the SNMP, please download the SNMP software and manager to receive the camera
information via SNMP port. By setting the Trap Address, the camera can send alarm event and
exception messages to a surveillance center.
NOTE:
The SNMP version you select should be the same as that of the SNMP software. And
you also need to use the different version according to the security level you required. SNMP
v1 provides no security and SNMP v2 requires password for access. And SNMP v3 provides
encryption and if you use the third version, HTTPS protocol must also be enabled.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
UPnP Settings
Figure 9-8
USER MANUAL| VX-2S-CPIR-W
63
- Quick Links:
- Camera Setup Options
Hide quick links:
Advertisement
Table of Contents
