Day/Night Scheduled-Switch - 3xLogic VX-2S-CPIR-W User Manual

►
When installing a camera to monitor a narrow scene, turn the camera 90 degrees or
rotate the 3-axis lens to 90 degrees, and set the rotate mode to on to obtain a normal
view of the scene with 9:16 aspect ratio. Use this method to help eliminate obstructions
such as walls, leading to a clearer field-of-vision.

Scene Mode: Choose the scene as indoor or outdoor according to the surveillance
environment.

Video Standard: 50 Hz and 60 Hz are selectable. Choose according to the different video
standards; normally 50 Hz for PAL standard and 60 Hz for NTSC standard.

Capture Mode: A selectable video input mode to meet field of view and requirements.

Lens Distortion Correction: For cameras equipped with motor-driven lens, image may
appear distorted to some extent. Turn on this function to correct the distortion.
Others
Some camera models support CVBS, SDI, or HDMI output. Set the local output ON or OFF
according to the actual device.

DAY/NIGHT SCHEDULED-SWITCH

The Day/Night scheduled-switch configuration interface enables you to set the camera parameters for
day and night separately, guaranteeing image quality under different illumination environments.
Figure 11-5
Steps:
1. Click the calendar icon to select the start time and the end time of the switch.
NOTES:
►
The start time and end time refer to the valid time for Day mode.
►
The time period can start and end on two days in a row. For example, if you set start time as
10:00 and end time as 1:00, the day mode will be activated at 10am in the morning and
stopped at 1am the next morning.
2. Click Common tab to configure the common parameters applicable to the day mode and night
mode.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
Day/Night Scheduled-Switch Configuration Interface
USER MANUAL| VX-2S-CPIR-W
80