Configuring Audio Settings - 3xLogic VX-2S-CPIR-W User Manual

►
You need to reboot the camera if you want to turn on or turn off the H.264+/H.265+
codec. If you switch from H.264+ to H.265+ directly, and vice versa, a reboot is not
required by the system.

Max. Average Bitrate: When you set a maximum bitrate, its corresponding recommended
maximum average bitrate will be shown in the Max. Average Bitrate box. You can also set the
maximum average bitrate manually from 32 Kbps to the value of the set maximum bitrate.

Profile: Basic profile, Main Profile, and High Profile for coding are selectable.

I Frame Interval: Set I Frame Interval from 1 to 400.

SVC: Scalable Video Coding is an extension of the H.264/AVC standard. Select OFF/ON to
disable/enable the SVC function. Select Auto and the device will automatically extract frames
from the original video when the network bandwidth is insufficient.

Smoothing: It refers to the smoothness of the stream. The higher the smoothing value, the
more fluid the stream will be, though video quality may be affected. The lower the
smoothing value, the higher quality the stream will be, though the footage may appear less
fluid.
4. Click Save to save the settings.
NOTE: Video parameters vary according to different camera models. Refer to the actual display page
for camera functions.

10.2 Configuring Audio Settings

Steps:
1. Enter the Audio Settings interface: Configuration > Video/Audio > Audio.
2. Configure the following settings:
NOTE: Audio settings vary according to different camera models.

Audio Encoding: G.722.1, G.711 ulaw, G.711alaw, G.726, MP2L2 and PCM are
selectable. For MP2L2, the Sampling Rate and Audio Stream Bitrate are configurable.
For PCM, the Sampling Rate can be set.

Audio Input: MicIn and LineIn are selectable for the connected microphone and
pickup respectively.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
Audio Settings
Figure 10-2
USER MANUAL| VX-2S-CPIR-W
74