Configuring Ddns Settings - 3xLogic VX-2S-CPIR-W User Manual

3. (Optional) Check the Enable Multicast Discovery checkbox to allow an online network camera to
be automatically detected by client software via private multicast protocol in the LAN.
4. Configure the DNS server. Input the preferred DNS server, and alternate DNS server.
5. Click Save to save the above settings.
NOTES:
►
The valid value range of MTU is 1280 to 1500.
►
The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
Before utilizing this function, you have to enable the Multicast function of your router.
►
A reboot is required for the settings to take effect.

CONFIGURING DDNS SETTINGS

If your camera is set to use PPPoE as its default network connection, you can use the Dynamic DNS
(DDNS) for network access.
Before you start:
Registration on the DDNS server is required before configuring the DDNS settings of the camera.
Steps:
1. Enter the DDNS Settings interface: Configuration > Network > Basic Settings > DDNS.
2. Check the Enable DDNS checkbox to enable this feature.
3. Select the DDNS Type. Four DDNS types are selectable: HiDDNS, IPServer, DynDNS and NO-IP.
DynDNS
Steps:
a. Enter the Server Address of the desired DynDNS (e.g. members.dyndns.org).
b. In the Domain text field, enter the domain name obtained from the DynDNS
website.
c. Enter the User Name and Password registered on the DynDNS website.
d. Click Save to save the settings.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
USER MANUAL| VX-2S-CPIR-W
58