Configuring External Devices; Configuring Vca Resource - 3xLogic VX-2S-CPIR-W User Manual

CONFIGURING EXTERNAL DEVICES

External Device settings apply to supported external devices, including a housing wiper or LED
lighting. Settings for these devices can be configured here. Supported external devices vary according
to different camera models.
Steps:
1. Enter the External Device configuration interface: Configuration > System > System Settings >
External Device
2. Check the Enable Supplement Light checkbox to enable the LED Light.
3. Move the slider to adjust the low beam brightness and high beam brightness.
4. Select the mode for LED light. Timing and Auto are selectable.

Timing: The LED will be turned according to the schedule. You should set the Start Time and
End Time.

Auto: The LED will be turned on according to the environment illumination.
5. Click Save to save the settings.

CONFIGURING VCA RESOURCE

The VCA Resource interface offers you options to enable certain VCA functions according to actual
need when several VCA functions are available. It helps allocate more resources to the required
functions.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
External Device Settings
Figure 8-9
Set Schedule
Figure 8-10
VCA Resource Configuration
Figure 8-11
USER MANUAL| VX-2S-CPIR-W
48