Table of Contents
Advertisement
1.
Navigate to configuration services routing on the source appliance.
Use a static /32 (host-specific) route to the target system IP address via the dedicated network
interface. In the following example, mask=32 means this is a host-specific route.
host_source:configuration services routing> create
host_source:configuration services route (uncommitted)> get
family = (unset)
destination = (unset)
mask = (unset)
gateway = (unset)
interface = (unset)
host_source:configuration services route (uncommitted)> set family=IPv4
host_source:configuration services route (uncommitted)> set destination=203.34.56.78
host_source:configuration services route (uncommitted)> set mask=32
host_source:configuration services route (uncommitted)> set gateway=203.34.56.254
host_source:configuration services route (uncommitted)> set interface=nge3
host_source:configuration services route (uncommitted)> commit
host_source:configuration services routing> show
route-000 0.0.0.0/0
route-001 203.24.30.0/32
route-002 203.24.150.0/32
route-003 203.24.101.65/32
route-005 203.34.56.78/32
2.
After defining the static route from the source appliance to the target appliance,
repeat these steps on the target appliance to define the static route from the
target back to the source.
3.
To ensure traffic is routed through the correct source and target interfaces, use
the traceroute command.
For information about using traceroute, see
When an interface is deleted, all routes associated with the interface are also removed.
Note -
Related Topics
"Remote Replication Workflow" on page 470
■
"Remote Replication Concepts" on page 526
■
Locking Cluster Management Interfaces (CLI)
After initial configuration, clustered controllers are in an active-active state. When a failover
occurs, an active controller takes over all non-private interfaces, and the peer controller
Locking Cluster Management Interfaces (CLI)
203.24.30.254
nge0
203.24.30.28
nge0
203.24.150.10
ibd0
203.24.30.254
nge1
203.34.56.254
nge3
"Configuring Network Routing" on page
Configuring the Appliance
static
dynamic
dynamic
inactive
static
85.
75
Advertisement
Table of Contents
