Table of Contents
Advertisement
Shutting Down a Clustered Configuration (BUI)
controller-a
Active (takeover completed)
Active (takeover completed)
Active (takeover completed)
3.
Log in to the BUI of Controller B and click the power icon
under the masthead.
Note -
From the BUI of Controller A, go to Configuration > Cluster to confirm that
4.
Controller B is powered off, with the cluster state: Unknown (disconnected or
restarting).
5.
From the BUI of Controller A, click the power icon
masthead.
6.
(Optional) To confirm that both controllers are powered off, log into the Oracle
ILOM and enter :
->show /SYS power_state
For information about accessing ILOM, see
Command Line Interface" in Oracle ZFS Storage Appliance Customer Service
Power off the disk shelves.
7.
a.
Place the power supply on/off switches to the "O" off position.
Disconnect the power cords from the external power source for the cabinet.
b.
Note -
198
Oracle ZFS Storage Appliance Administration Guide, Release OS8.6.x • September 2016
To limit the number of times a pool is moved, shut down the standby controller first.
All power cords must be disconnected to completely remove power from the disk shelf.
controller-b
Ready (waiting for failback)
Rejoining cluster ...
Unknown (disconnected or
restarting)
"Logging in to Oracle ILOM Remotely Using a
Condition
controller-a owns all of the
resources and is the active controller.
controller-b, is in standby mode
and has no resources. To limit the
number of times a pool is moved,
shut down the standby controller
first.
controller-b is rebooting and
controller-a has all resources.
controller-b is powered off
or rebooting, all of its cluster
interconnect links are down,
or clustering has not yet been
configured.
on the left side
on the left side under the
Manual.
Advertisement
Table of Contents
