Creating An Offline Replication (Bui); Setting Up An Nfs Server For Offline Replication - Oracle ZFS Storage Appliance Administration Manual

Creating an Offline Replication (BUI)

host_source:shares PROJECT1/SHARE1 action-000> sendupdate
When the update is currently active, the CLI shows a state of sending.
2. If the replication does not complete successfully, remove any old actions or
snapshots and start it again.
Related Topics
"Creating a Replication Action (CLI)" on page 478
■
"Canceling a Replication Update (CLI)" on page 505
■
Creating an Offline Replication (BUI)
Use the following procedures to create an offline replication update:
"Setting Up an NFS Server for Offline Replication" on page 482
■
"Setting Up an Export Path to the NFS Server (BUI)" on page 483
■
"Exporting a Replication Update (BUI)" on page 483
■
"Verifying the Replication Stream On the NFS Server" on page 484
■
"Importing the Replication Stream from the NFS Server (BUI)" on page 485
■
"Performing a Manual Network Update (BUI)" on page 485
■
"Reversing Replication for Offline Replication (BUI)" on page 485
■

Setting Up an NFS Server for Offline Replication

The steps for setting up an NFS server will vary depending on the NFS server type you use.
Refer to your NFS server documentation for specific instructions.
1. Identify a server that is network ready and has NFS Services enabled.
2. As root of the NFS server, create a filesystem or share.
Set the file permissions to expose the NFS share only to the IP address of the
3.
source and target appliances.
4. To encrypt the replication stream, enable on-disk encryption for the NFS share
on the NFS server.
482 Oracle ZFS Storage Appliance Administration Guide, Release OS8.6.x • September 2016