Reversing Replication Back To The Production Site (Cli) - Oracle ZFS Storage Appliance Administration Manual

3.
Select the action number and then enter sendupdate to start replication to the
production appliance.
host-offsite:shares pool new-kmm2 replication> select action-000
host-offsite:shares pool new-kmm2 action-000> sendupdate
4. Wait for the replication to complete.
The state changes to idle when the replication has completed.
Next Step
"Reversing Replication Back to the Production Site (CLI)" on page 523
■
Reversing Replication Back to the Production Site
(CLI)
After all changes have been replicated from the recovery site to the production site, reverse
replication again to restore the original replication relationship between source and target
appliances. Before reversing replication, delete the original project.
1. Delete the original project on the source appliance.
a.
Go to shares and select the original project.
host-prod:> shares select kmm2
b.
Confirm the project is empty by entering list. Then enter done.
host-prod:shares kmm2> list
host-prod:shares kmm2> done
c.
Go to shares and enter destroy and the name of the original project. Then
enter Y to confirm the action.
host-prod:> shares
host-prod:shares> destroy kmm2
This will destroy all data in "kmm2"! Are you sure? (Y/N)Y
2.
Go to shares and enter the following commands to list the source appliances that
use the original production appliance as a replication target.
host-prod:shares> replication
host-prod:shares replication> sources

Reversing Replication Back to the Production Site (CLI)

Remote Replication 523