Table of Contents
Advertisement
On clustered platforms, targets which have at least one active interface on that cluster node will
be online. Take care when assigning interfaces to targets; a target may be configured to use
portal groups on disjoint head nodes. In that situation, the target will be online on both heads
yet will export different LUNs depending on the storage owned by each head node. As network
interfaces migrate between cluster heads as part of takeover/failback or ownership changes,
iSCSI targets will move online and offline as their respective network interfaces are imported
and exported.
Targets which are bound to an IPMP interface will be advertised only via the addresses of that
IPMP group. That target will not be reachable via that group's test addresses. Targets bound
to interfaces built on top of a LACP aggregation will use the address of that aggregation. If a
LACP aggregation is added to an IPMP group, a target can no longer use that aggregation's
interface, as that address will become an IPMP test address.
Related Topics
Configuring FC Port Modes (BUI)
■
Discovering FC Ports (BUI)
■
Creating FC Initiator Groups (BUI)
■
Associating a LUN with an FC Initiator Group (BUI)
■
Changing FC Port Modes (CLI)
■
Discovering FC Ports (CLI)
■
Creating FC Initiator Groups (CLI)
■
Associating a LUN with an FC Initiator Group (CLI)
■
Scripting Aliases for Initiators and Initiator Groups (CLI)
■
Configuring SAN iSCSI Initiators
■
Creating an Analytics Worksheet (BUI)
■
Adding an iSCSI Target with an Auto-generated IQN (CLI)
■
Adding an iSCSI Target with a Specific IQN and RADIUS Authentication (CLI)
■
Adding an iSCSI Initiator with CHAP Authentication (CLI)
■
Adding an iSCSI Target Group (CLI)
■
Adding an iSCSI Initiator Group (CLI)
■
Configuring SRP Target (BUI)
■
Configuring SRP Targets (CLI)
■
SAN iSCSI Initiator Configuration
iSCSI initiators have the following configurable properties.
Configuring SRP Targets (CLI)
Configuring the Appliance
155
Advertisement
Table of Contents
