Setting Up Network Interfaces And Static Routing (Bui) - Oracle ZFS Storage Appliance Administration Manual

supported on the target appliance. Features are delivered with software updates or as deferred
updates.
For details about compatibility and deferred update features for each software version, see
the Oracle ZFS Storage Appliance Remote Replication Compatibility document (Doc ID
1958039.1) on
Check the current software version on the source and target appliances.
1.
If you are using the BUI, go to Maintenance > System. If you are using the CLI, navigate to
maintenance system updates and enter show.
Ensure the target appliance provides support for any deferred update feature
2.
used by the source project or share.
For example, if the source share uses large blocks, ensure that the target appliance provides
support for this feature.
Update software and apply deferred updates on the target appliance, as needed.
3.
For more information, see
Customer Service

Setting Up Network Interfaces and Static Routing (BUI)

To ensure the appropriate network interfaces are used for the replication connections between
source and target appliances, configure static /32 (host-specific) routes.
If you are setting up replication for a cluster configuration, select a singleton (unlocked)
network interface so that following a cluster takeover or failback, the interface will move to the
node where the replication work is being done. The two source cluster nodes can replicate to the
same target node only if the target node provides two IP addresses, one for use by each node in
the source cluster. Replicating to the same target IP address from both nodes of a source cluster
is not supported.
1. Go to the Configuration > Network > Routing page.
My Oracle Support (http://support.oracle.com/).
"Applying Deferred Updates" in Oracle ZFS Storage Appliance
Manual.
Setting Up Network Interfaces and Static Routing (BUI)
Remote Replication 471