Debugging; Configuration Examples; Example For Configuring Radius Authentication And Accounting - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
Example
Run the display aaa configuration command to view AAA running information.
<Quidway> display aaa configuration
Domain Name Delimiter
Domain
Authentication-scheme
Accounting-scheme
Authorization-scheme
Service-scheme

1.9.3 Debugging

Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
When a running fault occurs on the RADIUS or HWTACACS server, run the debugging
commands in the user view to locate the fault.
Procedure
l
l
----End

1.10 Configuration Examples

This section provides several configuration examples of AAA and user management.

1.10.1 Example for Configuring RADIUS Authentication and Accounting

1.10.2 Example for Configuring HWTACACS Authentication, Accounting, and Authorization
1.10.1 Example for Configuring RADIUS Authentication and
Accounting
Networking Requirements
As shown in
huawei. S9300-B acts as the network access server of the destination network. The access
request of the user needs to pass the network of S9300-A andS9300-B to reach the authentication
server. The user can access the destination network through S9300-B after passing the remote
authentication. The remote authentication mode on S9300-B is as follows:
Issue 06 (2010–01–08)
CAUTION
Run the debugging radius packet command to debug RADIUS packets.
Run the debugging hwtacacs { all | error | event | message | receive-packet | send-
packet } command to debug HWTACACS.
Figure 1-1, users access the network through S9300-A and are located in the domain
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
: @
: total: 128 used: 5
: total: 128 used: 1
: total: 128 used: 3
: total: 128 used: 1
: total: 128 used: 0
1-41