Call Cut-Through Parameters; Automatic Dialing Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Override-Override
dscp-4-mlpp-flsh-ov-ov
[MLPPFlashOverOverRTPDSCP]
65.10.5.10

Call Cut-Through Parameters

The call cut-through parameters are described in the table below.
Parameter
Enable Calls Cut
Through
configure voip > sip-
definition settings >
calls-cut-through
[CutThrough]
cut-through-anable
[DigitalCutThrough]
65.10.5.11

Automatic Dialing Parameters

The automatic dialing upon off-hook parameters are described in the table below.
Parameter
Automatic Dialing Table
Automatic Dialing Table
configure voip >
gateway analog
automatic-dialing
[TargetOfChannel]
User's Manual
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Table 65-51: Call Cut-Through Parameters
Global parameter enabling FXS endpoints to receive incoming IP calls
while the port is in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_IP2TelCutThroughCallBehavior). For a detailed
description of the parameter and for configuring the functionality in the Tel
Profiles table, see Configuring Tel Profiles on page 459.
Note:

The parameter is applicable only to FXS interfaces.

If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
Global parameter enabling PSTN CAS channels/endpoints to receive
incoming IP calls even if the B-channels are in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_DigitalCutThrough). For a detailed description of the
parameter and for configuring the functionality in the Tel Profiles table, see
Configuring Tel Profiles on page 459.
Note: If the functionality is configured for a specific Tel Profile, the settings
of the global parameter is ignored for calls associated with the Tel Profile.
Table 65-52: Automatic Dialing Parameters
Defines telephone numbers that are automatically dialed when a specific
FXS or FXO port is off-hooked. The format of the ini file table parameter is
as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
1148
Mediant 1000B Gateway & E-SBC
Description
Description
Description
Document #: LTRT-27055