Table 16: Description Of The Parameters Of The "Tcp/Ip" Page - WAGO -I/O-SYSTEM 750 User Manual

The following table explains the parameters listed on the page:

Table 16: Description of the Parameters of the "TCP/IP" Page

Common Configuration Data
Host Name
Default Gateway
None
X8
X9
Value
DNS Server
Domain Name
DNS Server 1
DNS Server 2
Add DNS Server
TCP/IP Configuration Eth0 (X8)/Eth1 (X9)
State
Enabled
Disabled
Type of Address Configuration
Static IP
DHCP
BootP
Configuration Data
IP Address
Subnet Mask
WAGO I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master
If you have chosen the dynamic assignment of an IP address
through DHCP, enter the host name of your PC here. This
makes it possible for your PC to be activated by the host name
in the LAN.
This is where you select the interface that should be used as
the default gateway. The default gateway is used by the I/O-
IPC if the target address lies outside of the individual network.
Enter the address of the default gateway here.
Set the domain name here.
Set the address of the DNS server here.
CHANGE: Accept the DNS address.
DELETE: Deletion of the DNS address (line is removed).
Set the address of the DNS server here.
CHANGE: Accept the DNS address.
DELETE: Deletion of the DNS address (line is removed).
Add additional DNS addresses here.
Activate the corresponding Ethernet interface here.
Deactivate the corresponding Ethernet interface here.
Here, choose whether you would like to use a static or
dynamic IP address.
Static IP: Static IP address
DHCP and BootP: Dynamic IP address
Here, enter a static IP address. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.
Here, enter the subnet mask. This is active if "Static IP" is
activated in the "Type of Address Configuration" field.
Configuration 63