Power Supply Module; Figure 9: Power Supply Module - WAGO -I/O-SYSTEM 750 User Manual

34 Description of I/O-IPC Interfaces
5.8

750-602 Power Supply Module

The field supply for the connected I/O modules, sensors and actuators is fed in
through the power supply module.
63
63

Figure 9: Power supply module

Position
60
61
62
63
64
44
61 62
60
63
LED/Operating Element
Earth
0 V DC
Field supply, 24 V DC
Power jumper contacts
Data contacts
LED
44
64
Color/ Meaning
Status
- Connection of protective earth
- Ground (GND) of the supply voltage
- 24V supply voltage for the sensors/actuators.
The power supply is protected against reverse
polarity.
For the supply of other field potentials; e.g.,
230 VAC, appropriate power supply modules
are available. You can find detailed
information on this in the manuals for the
power supply modules and in the 750-xxx
system description.
- Conduction of the field-side supply voltage to
the connected I/O modules.
- These make the supply voltage (5 V, 1 A)
available for the electronics in the I/O
modules connected to the internal data bus.
The supply voltage is provided by the I/O-
IPC (connection X4).
Green/off The LED lights up if the field supply is
available (see Pos. 62). Otherwise, the LED is
off.
I/O-IPC-C10E, CANopen Master
WAGO-I/O-SYSTEM 750