Interface For Electronic Power Supply (X4); Table 4: Interface For Electronic Power Supply: Pin Assignments - WAGO -I/O-SYSTEM 750 User Manual

5.2

Interface for Electronic Power Supply (X4)

Feed the electronic power supply for the I/O-IPC and for the I/O modules
connected to the internal data bus in through this interface.
Electric voltage!
Only operate the I/O-IPC with 24VDC PELV- (Protective Extra Low Voltage) or
SELV (Safety Extra Low Voltage) power sources. There is a danger of electric
shock if this precaution is not observed.

Table 4: Interface for Electronic Power Supply: Pin Assignments

Connector
3
2
WAGO I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master
DANGER
Pin
1
1
2
3
Description of I/O-IPC Interfaces
Description
V_IN (+)
GND (-)
Shield (optional)
25