Access Over Telnet; Figure 107: Dos Console 1; Figure 108: Dos Console 2 - WAGO -I/O-SYSTEM 750 User Manual

14.3.1.1

Access over Telnet

In order to access the I/O-IPC over Telnet, use a terminal program such as
minicom (under Linux) or hyperterminal (under Windows).
For use of the hyperterminal, the following settings in the login interface have to
be adapted:
Host address: IP address of the Ethernet interface of the I/O-IPC used
Connect via: TCP/IP
On top of that, you can also access the I/O-IPC through the textual console of
Linux or MS-DOS using Telnet. This procedure is described below:
1. Connect the X9 Ethernet interface of the I/O-IPC to your PC through an
Ethernet patch cable.
2. Open a console of your PC.
3. Enter the command

Figure 107: DOS console 1

4. Enter your user name (see Section 14.3.1).

Figure 108: DOS console 2

5. Enter the password for your user. The Linux console of the I/O-IPC opens
in the HOME directory (
WAGO I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master
telnet <IP-ADRESSE des I/O-IPC>
~
) of the selected user.
Linux 155
.