1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices (see "Turning off the system-board
3. If external cables are connected to the front of the system-board tray, note
4. Note where the hard disk drives are installed; then, remove them (see
≥ 18 kg (39.7 lb)
5. Remove the 2 screws and slide the 3U chassis from the iDataPlex rack.
6. Set the 3U chassis on a flat, static-protective surface.
Removing a system-board tray from a 2U chassis
Notes:
1. If two system-board trays are installed in the chassis, they can be removed
2. If an expansion enclosure is installed on the system-board tray, you will remove
on page 23.
tray" on page 21).
where they are connected; then, remove them.
Attention:
When you use RAID arrays, hard disk drives must be installed in
the same location from which they were removed.
"Removing a hard disk drive" on page 30).
Statement 4:
CAUTION:
Use safe practices when lifting.
independently of each other.
the expansion enclosure and the system-board tray from the chassis as one
assembly.
≥ 32 kg (70.5 lb)
Chapter 3. Installing optional devices
≥ 55 kg (121.2 lb)
25