Table of Contents
Advertisement
18. Install the ServeRAID adapter onto the RAID adapter carrier, and then install
19. Install the top cover bracket (see "Installing the top-cover bracket" on page 40).
20. Push the hard disk drives and hard disk drive fillers back into place so that
21. Install the top cover.
22. Connect the cables and power cords (see "Connecting the cables" on page
23. Turn on all attached devices and the server.
Installing an eXFlash 1.8-inch drive cage and backplane
Use the following instructions to install an eXFlash 1.9-inch drive cage when a
2.5-inch SAS hard disk drive backplane is also installed in the server.
To install an eXFlash 1.8-inch drive cage and backplane, complete the following
steps:
52
IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User's Guide
the carrier into the server.
Post
Tabs
they connect to the backplane.
71).
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 32.
2. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
3. Remove the server cover (see "Removing the top cover" on page 37).
Release
latch
Advertisement
Table of Contents
