Chapter 6
X330WAN CLI Commands
ip ospf dead-interval (Interface context)
Use the
declaring the neighbor as dead. The no form of this command sets the
dead-interval to its default. The default is 40.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf dead-interval <seconds>
Parameters
seconds
Example
ip ospf dead-interval 15
ip ospf hello-interval (Interface Mode)
Use the
hello packets the router sends. The no form of this command sets the hello-interval
to its default. The default is 10 seconds.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf hello-interval <seconds>
Parameters
seconds
Example
ip ospf hello-interval 5
180
ip ospf dead-interval
An integer from 1 to 415029.
ip ospf hello-interval
An integer from 1 to 65535.
command to configure the interval before
command to specify the time interval between
Avaya X330WAN User's Guide