Deny (Ipv6 Access-List Configuration) - Cisco Catalyst 3560-X Command Reference Manual

deny (IPv6 access-list configuration)

deny (IPv6 access-list configuration)
Note
Syntax Description
Catalyst 3750-X and 3560-X Switch Command Reference
2-138
Downloaded from www.Manualslib.com
Use the deny command in IPv6 access list configuration mode on the switch stack or on a standalone
switch to set deny conditions for an IPv6 access list. Use the no form of this command to remove the
deny conditions.
deny {protocol} {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address}
[operator [port-number]] [dscp value] [fragments] [log] [log-input] [routing] [sequence
value] [time-range name]
no deny {protocol} {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address}
[operator [port-number]] [dscp value] [fragments] [log] [log-input] [routing] [sequence
value] [time-range name]
Internet Control Message Protocol
deny icmp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address}
[operator [port-number]] [icmp-type [icmp-code] | icmp-message] [dscp value] [log]
[log-input] [routing] [sequence value] [time-range name]
Transmission Control Protocol
deny tcp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address}
[operator [port-number]] [ack] [dscp value] [established] [fin] [log] [log-input] [neq {port |
protocol}] [psh] [range {port | protocol}] [rst] [routing] [sequence value] [syn] [time-range
name] [urg]
User Datagram Protocol
deny udp {source-ipv6-prefix/prefix-length | any | host source-ipv6-address} [operator
[port-number]] {destination-ipv6-prefix/prefix-length | any | host destination-ipv6-address}
[operator [port-number]] [dscp value] [log] [log-input] [neq {port | protocol}] [range {port |
protocol}] [routing] [sequence value] [time-range name]
This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch. This command is not supported on switches running the
LAN base feature set.
protocol
source-ipv6-prefix/prefix-
length
manuals search engine
Chapter 2
Name or number of an Internet protocol. It can be one of the keywords ahp,
esp, icmp, ipv6, pcp, sctp, tcp, or udp, or an integer in the range from 0 to
255 representing an IPv6 protocol number.
The source IPv6 network or class of networks about which to set deny
conditions.
This argument must be in the form documented in RFC 2373 where the
address is specified in hexadecimal using 16-bit values between colons.
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02