Figure 3-75: Hunt Group Settings Page - AudioCodes Mediant 800 MSBG User Manual

3.3.2.11.1.2 Configuring Hunt Group Settings
The 'Hunt Group Settings' page allows you to configure the settings of up to 24 Hunt
Groups. These Hunt Groups are configured in the 'Hunt Group Table' page (see
Configuring Hunt Group Table on page 146).
This page allows you to select the method for which IP-to-Tel calls are assigned to
channels within each Hunt Group. If no method is selected for a specific Hunt Group, the
setting of the global parameter, ChannelSelectMode takes effect. In addition, this page
defines the method for registering Hunt Groups to selected Serving IP Group IDs (if
defined).
Note:
To configure the Hunt Group Settings table:
1. Open the 'Hunt Group Settings' page (Configuration tab > VoIP menu > GW and IP
to IP submenu > Hunt Group submenu > Hunt Group Settings).
2. From the 'Index' drop-down list, select the range of entries that you want to edit.
3. Configure the Hunt Group according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
An example is shown below of a REGISTER message for registering endpoint "101" using
registration Per Endpoint mode. The "SipGroupName" in the Request-URI is defined in the
IP Group table (see ''Configuring IP Groups'' on page 119).
REGISTER sip:SipGroupName SIP/2.0
Via: SIP/2.0/UDP 10.33.37.78;branch=z9hG4bKac862428454
From: <sip:101@GatewayName>;tag=1c862422082
To: <sip:101@GatewayName>
Call-ID: 9907977062512000232825@10.33.37.78
CSeq: 3 REGISTER
Contact: <sip:101@10.33.37.78>;expires=3600
Expires: 3600
User-Agent: Sip-Gateway/v.6.00A.008.002
Content-Length: 0
SIP User's Manual
You can also configure the 'Hunt Group Settings' table using the ini file table
parameter TrunkGroupSettings (see ''Number Manipulation and Routing
Parameters'' on page 836).

Figure 3-75: Hunt Group Settings Page

148
Mediant 800 MSBG
Document #: LTRT-12804