Configuring The Hunt Group Settings; Table 5-23: Endpoint Phone Number Table - AudioCodes MediaPack MP-11X User Manual

SIP User's Manual
Parameter
Channel(s)
Phone Number
Hunt Group ID
Profile ID
5.5.7

Configuring the Hunt Group Settings

The Hunt Group Settings option is used to determine the method in which new calls are
assigned to channels within each Hunt group. If such a rule doesn't exist (for a specific
Hunt group), the global rule, defined by the 'Channel Select Mode' parameter (Protocol
Definition > General Parameters), applies.
You can also configure the Hunt Group Settings table using the ini file parameter
TrunkGroupSettings (refer to 'Number Manipulation and Routing Parameters' on page
304).
Version 5.2

Table 5-23: Endpoint Phone Number Table

The numbers (1-8) in the Channel(s) fields represent the ports on the back
of the VoIP gateway. To enable a VoIP gateway channel, you must enter
the port (channel) number.
[n-m] represents a range of ports. For example, [1-4] specifies ports 1
through 4.
The telephone number that is assigned to the channel. For a range of
channels, enter the first number in an ordered sequence.
These numbers are also used for port allocation for IP to Tel calls, if the
hunt group's 'Channel Select Mode' is set to 'By Phone Number'.
The hunt group ID (1-99) assigned to the channel(s). The same hunt
group ID can be used for more than one channel and in more than one
field. The hunt group ID is an optional field that is used to define a group
of common behavior channels that are used for routing IP to Tel calls. If
an IP to Tel call is assigned to a hunt group, the call is routed to the
channel or channels that correspond to the hunt group ID.
You can configure the Hunt Group Settings table to determine the method
in which new calls are assigned to channels within the hunt groups (refer
to 'Configuring the Hunt Group Settings' on page 145).
Note: If you enter a hunt group ID, you must configure the IP to Hunt
Group Routing Table (assigns incoming IP calls to the appropriate hunt
group). If you do not configure the IP to Hunt Group Routing Table, calls
don't complete.
For information on how to configure this table, refer to 'IP to Hunt Group
Routing' on page 132.
The Tel profile ID that is assigned to the endpoints defined in the
'Channel(s)' field.
145
5. Web-based Management
Description
August 2007