AudioCodes Mediant 800 MSBG User Manual page 786

Parameter
Web/EMS: Clock Master
[ClockMaster]
[ClockMaster_x]
Web/EMS: Line Code
[LineCode]
[LineCode_x]
[TrunkAdministrativeState]
[TDMHairPinning]
Web: Enable TDM Tunneling
EMS: TDM Over IP
[EnableTDMoverIP]
SIP User's Manual
Determines the Tx clock source of the E1/T1 line.
[0] Recovered = Generate the clock according to the Rx of the
E1/T1 line (default).
[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:
The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
For detailed information on configuring the device's clock
settings, see ''Clock Settings'' on page 637.
Same as the description for parameter ClockMaster, but for a
specific Trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1 spans.
[0] B8ZS = use B8ZS line code (for T1 trunks only) default.
[1] AMI = use AMI line code.
[2] HDB3 = use HDB3 line code (for E1 trunks only).
Same as the description for parameter LineCode, but for a specific
trunk ID (where 0 depicts the first trunk).
Defines the administrative state of a trunk.
[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
[2] = Unlock the trunk (default); enables trunk traffic.
Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-Channel in each trunk.
Format example: T0-T1/B3,T2-T3,T4-T5/B2.
Note: For this parameter to take effect, a device reset is required.
Enables TDM tunneling.
[0] Disable = Disabled (default).
[1] Enable = TDM Tunneling is enabled.
When TDM Tunneling is enabled, the originating device
automatically initiates SIP calls from all enabled B-channels
pertaining to E1/T1/J1 spans that are configured with the
'Transparent' protocol. The called number of each call is the
internal phone number of the B-channel from where the call
originates. The 'Inbound IP Routing Table is used to define the
destination IP address of the terminating device. The terminating
device automatically answers these calls if its E1/T1 protocol is set
to 'Transparent' (ProtocolType = 5).
Notes:
For this parameter to take effect, a device reset is required.
For an overview on TDM tunneling, see ''TDM Tunneling'' on
page 647.
786
Mediant 800 MSBG
Description
Document #: LTRT-12804