Table 3-45: Hunt Group Settings Parameters Description; Figure 3-83: Hunt Group Settings - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
To configure the Hunt Group Settings table, take these 5 steps:
1. Open the 'Hunt Group Settings' page (Configuration tab > Protocol Configuration
menu > Hunt/IP Group submenu > Hunt Group Settings page item).
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
edit (up to 24 entries can be configured).
3. Configure the Hunt Group according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 207.

Table 3-45: Hunt Group Settings Parameters Description

Mode
Hunt Group ID
Channel Select
Mode
Version 5.4
Figure 3-83: Hunt Group Settings Page
The Hunt Group ID that you want to configure.
The valid range is 1-99.
Channels are assigned to Hunt Groups in the 'Endpoint Phone Numbers' page
(refer to "Configuring the Endpoint Phone Numbers" on page 179).
The method in which IP-to-Tel calls are assigned to channels pertaining to a
Hunt Group:
By Dest Phone Number = Selects the device's channel according to the
called number defined in the 'Endpoint Phone Number' (refer to "Configuring
the Endpoint Phone Numbers" on page 179).
Cyclic Ascending (default) = Selects the next available channel in an
ascending cyclic order. The next highest channel number in the Hunt Group
is always selected. When the highest channel number in the Hunt Group is
reached, the lowest channel number in the Hunt Group is selected, and then
it starts ascending again.
Ascending = Selects the lowest available channel. The lowest channel
number in the Hunt Group is always first selected, and if that channel is
unavailable, the next highest channel is selected.
Cyclic Descending = Selects the next available channel in descending
cyclic order. The next lowest channel number in the Hunt Group is always
first selected. When the lowest channel number in the Hunt Group is
reached, it selects the highest channel number in the Hunt Group and then
start descending again.
Descending = Selects the highest available channel. The highest channel
number in the Hunt Group is always first selected, and if that channel is
unavailable, the next lowest channel is selected.
Dest Number + Cyclic Ascending = The channel is first selected according to
the called number. If the called number isn't found, the next available
Description
181
3. Web-Based Management
May 2008