T Hree-Way Conferencing Parameters - AudioCodes Mediant 800 MSBG User Manual

Parameter
EMS: Blind Transfer Add Prefix
[KeyBlindTransferAddPrefix]
EMS: Blind Transfer Disconnect
Timeout
[BlindTransferDisconnectTimeout]
12.12.5.7 Three-Way Conferencing Parameters
The three-way conferencing parameters are described in the table below.
Parameter
Web: Enable 3-Way
Conference
EMS: Enable 3 Way
[Enable3WayConference]
Web: 3-Way Conference
Mode
EMS: 3 Way Mode
[3WayConferenceMode]
SIP User's Manual
Determines whether the device adds the Blind Transfer code
(KeyBlindTransfer) to the dialed destination number.
[0] Disable (default).
[1] Enable.
Note: This parameter is applicable only to FXO and FXS
interfaces.
Defines the duration (in milliseconds) for which the device
waits for a disconnection from the Tel side after the Blind
Transfer Code (KeyBlindTransfer) has been identified. When
this timer expires, a SIP REFER message is sent toward the
IP side. If this parameter is set to 0, the REFER message is
immediately sent.
The valid range is 0 to 1,000,000. The default is 0.
Table 12-44: Three-Way Conferencing Parameters
Enables or disables the 3-Way Conference feature.
[0] Disable = Disable (default)
[1] Enable = Enables 3-way conferencing
Note: For this parameter to take effect, a device reset is required.
Defines the mode of operation when the 3-Way Conference feature is
used.
[0] AudioCodes Media Server = The Conference-initiating INVITE
(sent by the device) uses the ConferenceID concatenated with a
unique identifier as the Request-URI. This same Request-URI is set
as the Refer-To header value in the REFER messages that are sent
to the two remote parties. This conference mode is used when
operating with AudioCodes IPMedia conferencing server. (Default)
[1] Non-AudioCodes Media Server = The Conference-initiating
INVITE (sent by the device) uses only the ConferenceID as the
Request-URI. The conference server sets the Contact header of the
200 OK response to the actual unique identifier (Conference URI) to
be used by the participants. This Conference URI is then included
(by the device) in the Refer-To header value in the REFER
messages sent by the device to the remote parties. The remote
parties join the conference by sending INVITE messages to the
conference using this conference URI.
[2] On Board = On-board three-way conference. The conference is
established on the device without the need of an external Conference
server.
Notes:
This parameter is applicable only to FXS interfaces.
When using an external conference server (i.e., options [0] or [1]),
Description
Description
772
Mediant 800 MSBG
Document #: LTRT-12804