AudioCodes Mediant 800 MSBG User Manual page 403

SIP User's Manual
Note:
The User Information file can be loaded to the device by using one of the following
methods:
ini file, using the parameter UserInfoFileName (described in ''Auxiliary and
Configuration Files Parameters'' on page 881)
Web interface (see ''Loading Auxiliary Files'' on page 337)
Automatic update mechanism, using the parameter UserInfoFileURL (refer to the
Product Reference Manual)
Each PBX extension registers separately (a REGISTER message is sent for each entry
only if AuthenticationMode is set to Per Endpoint) using the"Global phone number" in the
From/To headers. The REGISTER messages are sent gradually. Initially, the device sends
requests according to the maximum number of allowed SIP dialogs (configured by the
parameter NumberOfActiveDialogs). After each received response, the subsequent
request is sent. Therefore, no more than NumberOfActiveDialogs dialogs are active
simultaneously. The user name and password are used for SIP Authentication when
required.
The calling number of outgoing Tel-to-IP calls is translated to a "Global phone number"
only after Tel-to-IP manipulation rules (if defined) are performed. The Display Name is
used in the From header in addition to the "Global phone number". The called number of
incoming IP-to-Tel calls is translated to a PBX extension only after IP-to-Tel manipulation
rules (if defined) are performed.
Version 6.2
The last line in the User Information file must end with a carriage return (i.e.,
by pressing the <Enter> key).
403
7. Auxiliary Configuration Files
February 2011