Table 3-20: Account Table Parameters Description - AudioCodes Mediant 800 MSBG User Manual

Note:
Parameter
Served Trunk Group
[Account_ServedTrunkGroup]
Served IP Group
[Account_ServedIPGroup]
Serving IP Group
[Account_ServingIPGroup]
SIP User's Manual
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), see ''Working with Tables'' on page 53.

Table 3-20: Account Table Parameters Description

The Hunt Group ID for which you want to register and/or
authenticate to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Hunt Group is the source Hunt
Group from where the call originated. For IP-to-Tel calls, the
Served Hunt Group is the 'Trunk Group ID' defined in the 'Inbound
IP Routing Table' (see ''Configuring the Inbound IP Routing Table''
on page 172). For defining Hunt Groups, see Configuring the Hunt
Group Table on page 146.
Note: For the IP2IP application, this parameter must be set to -1
(i.e., no trunk).
The Source IP Group (e.g., IP-PBX) for which registration and/or
authentication is performed.
Note: This field is applicable only when the IP2IP application is
enabled.
The destination IP Group ID (defined in ''Configuring IP Groups'' on
page 119) to where the REGISTER requests (if enabled) are sent
or authentication is performed. The actual destination to where the
REGISTER requests are sent is the IP address defined for the
Proxy Set ID (see ''Configuring Proxy Sets Table'' on page 126)
associated with the IP Group. This occurs only in the following
conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the
'Hunt Group Settings' table (see ''Configuring Hunt Group
Settings'' on page 148).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served Hunt
Group/Served IP Group and Serving IP Group, the username and
password for digest authentication defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the 'Hunt Group Settings' table or 'Outbound IP
Routing Table' (see ''Configuring the Outbound IP Routing Table''
on page 165). For IP-to-Tel calls, the Serving IP Group is the
'Source IP Group ID' defined in the 'Inbound IP Routing Table' (see
''Configuring the Inbound IP Routing Table'' on page 172).
Note: If no match is found in this table for incoming or outgoing
calls, the username and password defined in the 'Authentication'
table for FXS interfaces (see Configuring Authentication on page
183) or the global parameters (UserName and Password) defined
on the 'Proxy & Registration' page.
Description
134
Mediant 800 MSBG
Document #: LTRT-12804