AudioCodes Mediant 800 MSBG User Manual page 760

Parameter
Web: Enable FXS Caller ID
Category Digit For Brazil Telecom
[AddCPCPrefix2BrazilCallerID]
[EnableCallerIDTypeTwo]
EMS: Caller ID Timing Mode
[AnalogCallerIDTimingMode]
SIP User's Manual
Enables the interworking of Calling Party Category (cpc) code
from SIP INVITE messages to FXS Caller ID first digit.
[0] Disable (default)
[1] Enable = Interworking of CPC is performed
When this parameter is enabled, the device sends the Caller ID
number (calling number) with the cpc code (received in the SIP
INVITE message) to the device's FXS port. The cpc code is
added as a prefix to the caller ID (after IP-to-Tel calling number
manipulation). For example, assuming that the incoming
INVITE contains the following From (or P-Asserted-Id) header:
From:<sip:+551137077801;cpc=payphone@10.20.7.35>;
tag=53700
The calling number manipulation removes "+55" (leaving 10
digits), and then adds the prefix 7, the cpc code for payphone
user. Therefore, the Caller ID number that is sent to the FXS
port, in this example is 71137077801.
If the incoming INVITE message doesn't contain the 'cpc'
parameter, nothing is added to the Caller ID number.
CPC Value in
Received INVITE Prefixed to Caller
cpc=unknown
cpc=subscribe
cpc=ordinary
cpc=priority
cpc=test
cpc=operator
cpc=data
cpc=payphone
Notes:
This parameter is applicable only to FXS interfaces.
For this parameter to be enabled, you must also set the
parameter EnableCallingPartyCategory to 1.
Disables the generation of Caller ID type 2 when the phone is
off-hooked. Caller ID type 2 (also known as off-hook Caller ID)
is sent to a currently busy telephone to display the caller ID of
the waiting call.
[0] = Caller ID type 2 isn't played.
[1] = Caller ID type 2 is played (default).
Determines when Caller ID is generated.
[0] = Caller ID is generated between the first two rings
(default).
[1] = The device attempts to find an optimized timing to
760
Mediant 800 MSBG
Description
CPC Code Description
ID (Sent to FXS
Endpoint)
1 Unknown user
1 -
1 Ordinary user
2 Pre-paid user
3 Test user
5 Operator
6 Data call
7 Payphone user
Document #: LTRT-12804