Figure 3-134: Shdsl Line Mode - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
Multiple wire-pairs are bonded into a single broadband access link using G.991.2 multiple-
pair (also known as "m-pair") technology when the transmission control is ATM, or by
802.3ah PMD Aggregation Function (PAF) when using Ethernet in the First Mile (EFM).
To configure the SHDSL WAN interface:
1. Obtain the connection information from your ISP, including the following data:
•
Transmission control type (ATM or EFM)
•
Line rate (automatic or specific range)
•
Regional annex (A/F or B/G)
•
Number of copper wire-pairs used and the order (i.e., one pair is the master, the
others are slaves)
•
VPI and VCI values
•
IP encapsulation (PPPoE, PPPoA, ETHoA, IPoA) and variant (LLC-SNAP or VC
multiplexing)
•
ATM service class information (CBR/VBR/UBR and data rates)
2. Open the 'SHDSL Line Settings' page (Configuration tab > Data menu > WAN
Access > SHDSL Line Settings).
3. Select ATM or EFM mode of operation. Note that any change to this setting erases all
SHDSL configuration; after switching modes, save the configuration to flash and reset
the device.
Version 6.2
Figure 3-134: SHDSL Line Mode Page
235
3. Web-Based Management
February 2011