AudioCodes Mediant 800 MSBG User Manual page 801

SIP User's Manual
Parameter
[ISDNRxOverlap]
Web/EMS: Mute DTMF In Overlap
[MuteDTMFInOverlap]
[ConnectedNumberType]
[ConnectedNumberPlan]
Web/EMS: Enable ISDN Tunneling
Tel to IP
[EnableISDNTunnelingTel2IP]
Version 6.2
a timer expires (e.g., for open numbering schemes). If a
match is found (or the timer expires), the digit collection
process is terminated even if Sending Complete is not
received.
For enabling ISDN overlap dialing for IP-to-Tel calls, use the
ISDNTxOverlap parameter.
For detailed information on ISDN overlap dialing, see ''ISDN
Overlap Dialing'' on page 642.
Same as the description for parameter ISDNRxOverlap_x, but
for all trunks.
Enables the muting of in-band DTMF detection until the device
receives the complete destination number from the ISDN (for
Tel-to-IP calls). In other words, the device does not accept
DTMF digits received in the voice stream from the PSTN, but
only accepts digits from ISDN Info messages.
[0] Don't Mute (default)
[1] Mute DTMF in Overlap Dialing = The device ignores in-
band DTMF digits received during ISDN overlap dialing
(disables the DTMF in-band detector).
Notes:
When enabled and at least one digit is received from the
ISDN (Setup message), the device stops playing a dial tone.
This parameter is applicable only to ISDN Overlap mode
when dialed numbers are sent using Q.931 Info messages.
Defines the Numbering Type of the ISDN Q.931 Connected
Number IE that the device sends in the Connect message to
the ISDN (for Tel-to-IP calls). This is interworked from the P-
Asserted-Identity header in SIP 200 OK.
The default is [0] (i.e., unknown).
Defines the Numbering Plan of the ISDN Q.931 Connected
Number IE that the device sends in the Connect message to
the ISDN (for Tel-to-IP calls). This is interworked from the P-
Asserted-Identity header in SIP 200 OK.
The default is [0] (i.e., unknown).
Enables ISDN Tunneling.
[0] Disable = Disable (default).
[1] Using Header = Enable ISDN Tunneling from ISDN PRI
to SIP using a proprietary SIP header.
[2] Using Body = Enable ISDN Tunneling from ISDN PRI to
SIP using a dedicated message body.
When ISDN Tunneling is enabled, the device sends all ISDN
PRI messages using the correlated SIP messages. The ISDN
Setup message is tunneled using SIP INVITE, all mid-call
messages are tunneled using SIP INFO, and ISDN
Disconnect/Release message is tunneled using SIP BYE
messages. The raw data from the ISDN is inserted into a
proprietary SIP header (X-ISDNTunnelingInfo) or a dedicated
message body (application/isdn) in the SIP messages.
801
12. Configuration Parameters Reference
Description
February 2011