Figure 3-148: Configuring Port Triggering - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
To configure port triggering:
1. Click the Port Triggering item (Configuration tab > Data menu > Firewall and ACL
submenu > Port Triggering); the following page appears:
2. From the drop-down list, you can select a pre-configured service by selecting 'Show
All Services', and then from the refreshed drop-down list, selecting a service.
If you want to define your own service, select 'User-Defined'; the following page
appears:
3. In the 'Service Name', enter a name for the service (e.g. "game_server"), and then
under the 'Outgoing Trigger Ports' group, click the New Trigger Ports link; the
following page appears:
4. From the 'Protocol' drop-down lists, select the protocol (e.g., 'UDP'); the 'Source Ports'
and 'Destination Ports' fields appear.
5. Leave the 'Source Ports' value at its default 'Any'.
6. In the 'Destination Ports' drop-down list, select 'Single'; a field for entering the
destination port appears (enter the destination port, e.g., "2222").
7. Click OK to save the settings.
8. Under the 'Incoming Ports to Open' group, click the New Opened Ports link, and then
configure the incoming ports by repeating steps 4 through 7, but entering values for
incoming ports.
Version 6.2

Figure 3-148: Configuring Port Triggering

Figure 3-149: Editing Port Triggering Rule
Figure 3-150: Defining Trigger Ports
245
3. Web-Based Management
February 2011