AudioCodes Mediant 800 MSBG User Manual page 879

SIP User's Manual
Parameter
Web: AGC Redirection
EMS: Redirection
[AGCRedirection]
Web: AGC Target Energy
EMS: Target Energy
[AGCTargetEnergy]
EMS: Minimal Gain
[AGCMinGain]
EMS: Maximal Gain
[AGCMaxGain]
EMS: Disable Fast Adaptation
[AGCDisableFastAdaptation]
Energy Detector Parameters
Note: Currently, this feature is not supported.
Enable Energy Detector
[EnableEnergyDetector]
Energy Detector Quality Factor
[EnergyDetectorQualityFactor]
Energy Detector Threshold
[EnergyDetectorThreshold]
Version 6.2
[25] 25 = 20.00 dB/sec
[26] 26 = 25.00 dB/sec
[27] 27 = 30.00 dB/sec
[28] 28 = 35.00 dB/sec
[29] 29 = 40.00 dB/sec
[30] 30 = 50.00 dB/sec
[31] 31 = 70.00 dB/sec
Determines the AGC direction.
[0] 0 = AGC works on signals from the TDM side (default).
[1] 1 = AGC works on signals from the IP side.
Determines the signal energy value (dBm) that the AGC attempts
to attain.
The valid range is 0 to -63 dBm. The default value is -19 dBm.
Defines the minimum gain (in dB) by the AGC when activated.
The range is 0 to -31. The default is -20.
Note: For this parameter to take effect, a device reset is required.
Defines the maximum gain (in dB) by the AGC when activated.
The range is 0 to 18. The default is 15.
Note: For this parameter to take effect, a device reset is required.
Disables the AGC Fast Adaptation mode.
[0] = Disable (default)
[1] = Enable
Note: For this parameter to take effect, a device reset is required.
Activates the Energy Detector feature. This feature generates
events (notifications) when the signal received from the PSTN is
higher or lower than a user-defined threshold (defined by the
EnergyDetectorThreshold parameter).
[0] Disable (default)
[1] Enable
Determines the Energy Detector's sensitivity level.
The valid range is 0 to 10, where 0 is the lowest sensitivity and 10
the highest sensitivity. The default is 4.
Defines the Energy Detector's threshold. A signal below or above
this threshold invokes an 'Above' or 'Below' event.
The threshold is calculated as follows:
Actual Threshold = -44 dBm + (EnergyDetectorThreshold * 6)
The valid value range is 0 to 7. The default is 3 (i.e., -26 dBm).
879
12. Configuration Parameters Reference
Description
February 2011