Restoring Factory Default Settings - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
6

Restoring Factory Default Settings

You can restore the device's configuration to factory defaults using one of the following
methods:
Using the CLI (see ''Restoring Defaults using CLI'' on page 391)
Loading an empty ini file (see ''Restoring Defaults using an ini File'' on page 392)
Using the hardware Reset button (see Restoring Defaults using Hardware Reset
Button on page 392)
6.1 Restoring Defaults using CLI
The device can be restored to factory defaults using CLI, as described in the procedure
below.
To restore factory defaults using CLI:
1. Access the device's CLI:
a. Connect the device's RS-232 port (refer to the Installation Manual) to COM1 or
COM2 communication port on your PC.
b. Establish serial communication with the device, using a serial communication
program (such as HyperTerminal
settings:
♦
♦
♦
♦
♦
2. At the initial CLI prompt, type the username (default is 'Admin'), and then press the
Enter key.
3. At the Password prompt, type the password (default is 'Admin'), and then press the
Enter key.
4. At the prompt, type the following, and then press the Enter key:
enable
5. At the Password prompt, type the password (default is 'Admin'), and then press the
Enter key.
6. At the prompt, type the following, and then press the Enter key:
configure system
7. At the prompt, type the following command to reset the device to default settings, and
then press the Enter key:
write factory
Version 6.2
Baud Rate: 115,200 bps
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
6. Restoring Factory Default Settings
) with the following communication port
TM
391 February 2011