I Sdn Parameters - AudioCodes Mediant 800 MSBG User Manual

12.12.6.4 ISDN Parameters
The ISDN parameters are described in the table below.
Parameter
Web: ISDN Termination Side
EMS: Termination Side
[TerminationSide]
[TerminationSide_x]
BRI Layer 2 Mode
[BriLayer2Mode]
Web/EMS: B-channel Negotiation
[BchannelNegotiation]
SIP User's Manual
Table 12-54: ISDN Parameters
Selects the ISDN termination side.
[0] User side = ISDN User Termination Equipment (TE)
side (default)
[1] Network side = ISDN Network Termination (NT) side
Note: Select 'User side' when the PSTN or PBX side is
configured as 'Network side' and vice versa. If you don't
know the device's ISDN termination side, choose 'User side'.
If the D-channel alarm is indicated, choose 'Network Side'.
The BRI module supports the ITU-T I.430 standard, which
defines the ISDN-BRI layer 1 specification. The BRI ports
are configured similarly, using this parameter. When an NT
port is active, it drives a 38-V line and sends an INFO1
signal (as defined in ITU-T I.430 Table 4) on the data line to
synchronize to a TE port that might be connected to it. To
stop the voltage and the INFO1 signal on the line, stop the
trunk using the Stop Trunk button.
Same as the description for parameter TerminationSide, but
for a specific trunk ID (where x denotes the Trunk ID and 0 is
the first Trunk).
Determines whether Point-to-Point or Point-to-Multipoint
mode for BRI ports.
[0] Point to Point (default)
[1] Point to Multipoint = Must be configured for Network
side.
Determines the ISDN B-Channel negotiation mode.
[0] Preferred.
[1] Exclusive (default).
[2] Any.
Notes:
This parameter is applicable only to ISDN protocols.
For some ISDN variants, when 'Any' (2) is selected, the
Setup message excludes the Channel Identification IE.
The 'Any' (2) option is applicable only if the following
conditions are met:
The parameter TerminationSide is set to 0 ('User
side').
The PSTN protocol type (ProtocolType) is configured
as Euro ISDN.
792
Mediant 800 MSBG
Description
Document #: LTRT-12804