AudioCodes Mediant 800 MSBG User Manual page 812

Parameter
Web: Enable User-to-User IE for
Tel to IP
EMS: Enable UUI Tel 2 Ip
[EnableUUITel2IP]
Web: Enable User-to-User IE for IP
to Tel
EMS: Enable UUI Ip 2 Tel
[EnableUUIIP2Tel]
[Enable911LocationIdIP2Tel]
[EarlyAnswerTimeout]
SIP User's Manual
Profile ID in the 'Inbound IP Routing Table' (PSTNPrefix).
When IP Profiles are used for configuring different IE data
for Hunt Groups, this parameter is ignored.
Enables ISDN PRI-to-SIP interworking.
[0] Disable = Disabled (default).
[1] Enable = Enable transfer of User-to-User (UU) IE from
PRI to SIP.
The device supports the following ISDN PRI-to-SIP
interworking: Setup to SIP INVITE, Connect to SIP 200 OK,
User Information to SIP INFO, Alerting to SIP 18x response,
and Disconnect to SIP BYE response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI
variants.
Enables SIP-to-PRI ISDN interworking.
[0] Disable = Disabled (default).
[1] Enable = Enable transfer of User-to-User (UU) IE from
SIP INVITE message to PRI Setup message.
The device supports the following SIP-to-PRI ISDN
interworking: SIP INVITE to Setup, SIP 200 OK to Connect, SIP
INFO to User Information, SIP 18x to Alerting, and SIP BYE to
Disconnect.
Notes:
The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI
variants.
To interwork the UUIE header from SIP-to-ISDN messages
with the 4ESS ISDN variant, the parameter
ISDNGeneralCCBehavior must be set to 16384.
Enables interworking of Emergency Location Identification from
SIP to PRI.
[0] = Disabled (default)
[1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN IE's:
Emergency Call Control.
Generic Information - to carry the Location Identification
Number information.
Generic Information - to carry the Calling Geodetic Location
information.
Note: This capability is applicable only to the NI-2 ISDN
variant.
Defines the time (in seconds) that the device waits for an ISDN
Connect message from the called party (Tel side) after sending
a Setup message. If the timer expires, the call is answered by
sending a SIP 200 OK message (IP side).
The valid range is 0 to 600. The default value is 0 (i.e.,
disabled).
812
Mediant 800 MSBG
Description
Document #: LTRT-12804