AudioCodes Mediant 800 MSBG User Manual page 766

Parameter
Call Forward Reminder Ring Parameters
Notes:
These parameters are applicable only to FXS interfaces.
For a description of this feature, see Call Forward Reminder Ring on page 458.
Web: Enable NRT
Subscription
[EnableNRTSubscription]
SIP User's Manual
[1] On Busy = Forward incoming calls when the port is busy.
[2] Unconditional = Always forward incoming calls.
[3] No Answer = Forward incoming calls that are not
answered within the time specified in the 'Time for No Reply
Forward' field.
[4] On Busy or No Answer = Forward incoming calls when
the port is busy or when calls are not answered within the
time specified in the 'Time for No Reply Forward' field.
[5] Do Not Disturb = Immediately reject incoming calls.
Destination = Telephone number or URI (<number>@<IP
address>) to where the call is forwarded.
NoReplyTime = Timeout (in seconds) for No Reply. If you have
set the Forward Type for this port to No Answer [3], enter the
number of seconds the device waits before forwarding the call to
the specified phone number.
Module = Module number (where 1 depicts the module in Slot 1).
Port = Port number (where 1 depicts Port 1 of a module).
For example:
Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;
Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
Notes:
The indexing of this parameter starts at 0.
Ensure that the Call Forward feature is enabled (default) for the
settings of this table parameter to take effect. To enable Call
Forwarding, use the parameter EnableForward.
If the parameter FwdInfo_Destination only contains a telephone
number and a Proxy isn't used, the 'forward to' phone number
must be specified in the 'Outbound IP Routing Table' (Prefix ini
file parameter).
For configuring this table using the Web interface, see
Configuring Call Forward on page 186.
For an explanation on using ini file table parameters, see
Configuring ini File Table Parameters on page 368.
Enables Endpoint subscription for Ring reminder event notification
feature.
[0] Disable (default)
[1] Enable
766
Mediant 800 MSBG
Description
Document #: LTRT-12804