Figure 8-109: Enabling Proxy Server For Gateway Application - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
8.5.3.4.1 Gateway with SAS Outbound Mode
The procedure below describes how to configure the Gateway application with SAS
outbound mode.
To configure Gateway application with SAS outbound mode:
1. Define the proxy server address for the Gateway application:
a. Open the 'Proxy & Registration' page (Configuration tab > VoIP menu > SIP
Definitions submenu > Proxy & Registration).
b. From the 'Use Default Proxy' drop-down list, select 'Yes'.

Figure 8-109: Enabling Proxy Server for Gateway Application

c. Click Submit.
d. Open the 'Proxy Sets Table' page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
e. From the 'Proxy Set ID' drop-down list, select '0'.
f. In the first 'Proxy Address' field, enter the IP address and port of the device (in
the format x.x.x.x:port). This is the port as defined in the 'SAS Local
UDP/TCP/TLS Port' field (see ''Configuring Common SAS Parameters'' on page
591).
Figure 8-110: Defining Proxy Server for Gateway Application
g. Click Submit.
Version 6.2 595
8. IP Telephony Capabilities
February 2011