Table 3-37: Ip To Ip Outbound Manipulation Table Parameters; Figure 3-111: Ip To Ip Outbound Manipulation - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
To configure IP-to-IP outbound manipulation rules:
1. Open the 'IP to IP Outbound Manipulation' page (Configuration tab > VoIP menu >
SBC submenu > Manipulations SBC submenu > IP to IP Outbound).
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.

Table 3-37: IP to IP Outbound Manipulation Table Parameters

Parameter
Matching Characteristics
Is Additional Manipulation
[IsAdditionalManipulation]
Manipulated URI
[IsAdditionalManipulation]
Source IP Group ID
[SrcIPGroupID]
Destination IP Group ID
[DestIPGroupID]
Version 6.2
Figure 3-111: IP to IP Outbound Manipulation Page
Determines whether additional SIP URI user part manipulation is done
for the table entry rule listed directly above it.
[0] 0 = Regular manipulation rule - not done in addition to the rule
above it (default).
[1] 1 = If the previous table row entry rule matched the call, consider
this row entry as a match as well and perform the manipulation
specified by this rule.
Note: Additional manipulation can only be performed on a different SIP
URI (either source or destination) to the rule configured in the row
above (defined by the parameter ManipulatedURI).
Determines whether the source or destination SIP URI user part is
manipulated.
[0] Source = Manipulation is done on the source SIP URI user part
(default).
[1] Destination = Manipulation is done on the destination SIP URI
user part.
The Source IP Group to which the INVITE belongs. For any Source IP
Group, enter the value -1.
The Destination IP Group to where the INVITE is sent. For any
Destination IP Group, enter the value -1.
Description
213
3. Web-Based Management
February 2011