Viewing Ip Connectivity; Table 3-46: Ip Connectivity Parameters - AudioCodes Mediant 800 MSBG User Manual

3.5.2.7

Viewing IP Connectivity

The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Outbound IP Routing Table'
page (see ''Configuring Outbound IP Routing Table'' on page 165).
Notes:
To view IP connectivity information:
1. In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel
to IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2].
2. Open the 'IP Connectivity' page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Column Name
IP Address The IP address can be one of the following:
Host Name Host name (or IP address) as defined in the 'Outbound IP Routing Table'.
Connectivity The method according to which the destination IP address is queried
Method periodically (ICMP ping or SIP OPTIONS request).
Connectivity The status of the IP address' connectivity according to the method in the
Status 'Connectivity Method' field.
SIP User's Manual
•
This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (see ''Configuring General Routing
Parameters'' on page 164) is set to 1 (Enable) or 2 (Status Only).
•
The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
Figure 3-311: IP Connectivity Page

Table 3-46: IP Connectivity Parameters

IP address defined as the destination IP address in the 'Outbound IP
Routing Table'.
IP address resolved from the host name defined as the destination IP
address in the 'Outbound IP Routing Table'.
OK = Remote side responds to periodic connectivity queries.
Lost = Remote side didn't respond for a short period.
Description
356
Mediant 800 MSBG
Document #: LTRT-12804