Table 3-35: Message Manipulations Parameters - AudioCodes Mediant 800 MSBG User Manual

The previous figure shows the following message manipulation rules:
•
Index 1: adds the suffix ".com" to the host part of the To header.
•
Index 2: changes the user part of the SIP From header to 200.
•
Index 3: changes the user part of the From header to the user part of the P-
Asserted-ID.
•
Index 4: if the user part of the From header equals "unknown", then it is changed
according to the srcIPGroup call's parameter.
•
Index 5: removes the Priority header from an incoming INVITE message.
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
Note:
Parameter
Manipulation Set ID
[ManSetID]
Matching Characteristics
Message Type
[MessageType]
Condition
[Condition]
SIP User's Manual
For a detailed description on the syntax for configuring SIP message
manipulation rules, see ''SIP Message Manipulation Description'' on page
506.

Table 3-35: Message Manipulations Parameters

Unique manipulation set ID that you can later assign to an IP Group (see
''Configuring IP Groups'' on page 119). In the IP Group, this manipulation
rule can be applied on the inbound and/or outbound message.
SIP message type that you want to manipulate.
The valid value is a string depicting the SIP message.
For example:
Empty = rule applies to all messages
Invite = rule applies to all INVITE requests and responses
Invite.Request = rule applies to INVITE requests
Invite.Response = rule applies to INVITE responses
subscribe.response.2xx = rule applies to SUBSCRIBE confirmation
responses
Note: Currently, SIP 100 Trying messages cannot be manipulated.
Condition that must exist for the rule to apply.
The valid value is a string.
For example:
header.from.url.user== 100 (indicates that the user part of the From
header must have the value "100")
header.contact.param.expires > 3600
header.to.url.host contains 'domain'
param.call.dst.user != 100
Note: Currently, SDP body message types are not supported.
Description
208
Mediant 800 MSBG
Document #: LTRT-12804