3.3.2.11 Gw And Ip To Ip - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
4. From the 'Profile Preference' drop-down list, select the priority of the IP Profile, where
'1' is the lowest priority and '20' is the highest. If both IP and Tel profiles apply to the
same call, the coders and other common parameters (noted by an asterisk) of the
preferred Profile are applied to that call. If the Preference of the Tel and IP Profiles is
identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5. Configure the IP Profile's parameters according to your requirements.
6. From the 'Coder Group' drop-down list, select the coder group that you want to assign
to the IP Profile. You can select the device's default coders (see ''Configuring Coders''
on page 139), or one of the coder groups you defined in the 'Coder Group Settings'
page (see ''Configuring Coder Groups'' on page 140).
7. Repeat steps 2 through 6 for the next IP Profiles (optional).
8. Click the Submit button to save your changes.
9. To save the changes to flash memory, see ''Saving Configuration'' on page 336.

3.3.2.11 GW and IP to IP

The GW and IP to IP submenu configures the gateway as well as IP-to-IP parameters and
includes the following page items:
Trunk Group (see Hunt Group on page 145)
Manipulations (see Manipulation on page 151)
Routing (see Routing on page 164)
DTMF and Supplementary (see ''DTMF and Supplementary'' on page 177)
Analog Gateway (see Analog Gateway on page 179)
Digital Gateway (see Digital Gateway on page 190)
Advanced Applications (see Advanced Applications on page 193)
Note:
3.3.2.11.1 Hunt Group
The Hunt Group submenu allows you to configure groups of channels called Hunt Groups.
This submenu includes the following page items:
Hunt Group Table (see Configuring Hunt Group Table on page 146)
Hunt Group Settings (see ''Configuring Hunt Group Settings'' on page 148)
Version 6.2
The IP-to-IP application will be supported in the next applicable release.
145
3. Web-Based Management
February 2011